Friedrich WY12D33A Handbuch PDF herunterladen (Seite 9)

STEP 1

STEP 2

STEP 3

STEP 1

STEP 4

STEP 2

STEP 3

STEP 4

NOTICE

SLEEVE projections and leveling precautions

must be observed to prevent the entry of

water into the room.

WSE

61603304

OUTDOOR WEATHER PANEL (PAINTED METAL)

61603012 ASSY GRILLE WSE SLEEVE

61578101

GASKET (ATTACHED TO SLEEVE)

The WSE SLEEVE should be positioned so that the

DRAIN EXTENSION extends a minimum of 9/16”

beyond the OUTSIDE WALL. (See Figure 5)

The WSE SLEEVE must extend a minimum of 7/8”

beyond the INSIDE WALL.

The WSE SLEEVE must be installed level side to side.

The WSE SLEEVE must also be installed with a

downward tilt toward the outside of the building. If a

level is placed so that it rests on the FRONT and BACK

UNIT REST as shown in Figure 6, a properly installed

unit provides a 3/8” slope to the outside of the building

After unpacking the WSE SLEEVE from the carton,

remove the INDOOR WEATHER PANEL. Place

the WSE SLEEVE in the wall opening following the

instructions given in the INSTALLATION

REQUIREMENTS. Attach the SLEEVE to the INSIDE

WALL by driving two #12A x 2” screws in each side of

the SLEEVE. (see Figure

5) Shim at the top of the

SLEEVE, midway between the sides. Drive one #12A

x 2” screw in the top of the SLEEVE. If the wall opening

is not framed with wood, use expansion anchor bolts

or molly (toggle) bolts (not provided).

Once the SLEEVE has been installed, check the LEVEL

again to be sure the 3/8” downward slope is

maintained.

NOTE: If necessary, apply shims below the chassis

and inside the sleeve FRONT UNIT REST, to ensure

a 3/8” downward slope front to back.

Caulk the perimeter of the entire opening on the

inside and the outside between the SLEEVE and the

WALL.

The indoor weather panel removed in Step 1 above

must be remounted back in place if masonry work is

to be done and/or if the “WallMaster”chassis is to be

installed at a later date.

SLEEVE

SHIM TO

PROPER SPA CING

FRONT UNIT REST

LEVEL

BACK UNIT REST

CAULK

(AS NEEDED)

CAULK

(AS NEEDED)

CAULK

(AS NEEDED)

BACK OF UNIT

FRONT OF UNIT

3/8 SLOPE

FIGURE 6

61603200

INDOOR WEATHER PANEL (METAL)

Sleeve Installation

Installation Requirements

How to cover inner weather panel holes

Two beige plugs are included in the plastic bag

taped to the WallMaster chassis. These plugs may be

used to cover the two holes left after removing the

indoor weather panel.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 42 43

Kommentare zu diesen Handbüchern

Keine Kommentare

Friedrich WY12D33A Handbuch Seite 9

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Friedrich WY12D33A